Steering Bulkhead Bearing TVRCarparts Metal TypeĪllen head bolts not essential but make life easierġ0.9 Strength setscrew. ![]() Steering Bulkhead Bearing Original Plastic Note Rally Design Forged UJ needs 40mm bolts ![]() Torque setting 77 - 92 Nm or 57 - 68 lb ft Note - the S4 has a V8S chassis - so where it refers to V8 this may also apply to the S4.Īs with anything TVR there may be variations!Īcknowledgement to Ken (Spludge) for producing the original excel list which this is based on. COUPLE DE SERRAGE le type M dune vis ou dun boulon veut dire que cest du pas metrique la CLASSE de la vis est sa dureté (limite a laquelle la vis casse exemple 8.8 80kg ) La classe de résistance de la matière 4.6 5.6 6.8 8.8 10.9 12. Steve does a suspension bolt kit which does take some of the pain away.Įbay seller - jez1964 - certainly good for V8 engine bolts as I (Barkychoc) have used them on my engine. a good but not especially cheap source of imperial and metric bolts, but not the trailing arm pivot bolts, for those use Steve Heath below. Suspension Bushes).Īll bolt lengths are measured from under the head to the end. ![]() Must be used where radial loads exist (e.g. Sur une jante en acier, les boulons les plus souvent employés sont des boulons de 10, 12 ou 14 mm. Setscrew = Fully threaded from under head to end.īolt = Part plain shaft part threaded. NotesPenny Washer = Extra Large Diameter washer with stated bolt diameter hole.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |